CAMPAGNOLA Cobra V.Evo Manual De Uso Y Mantenimiento página 35

Visualization of the daily cuts number: It shows the cuts quantity performed daily. This value can be zeroed.
Press the display button (22) till the "day" function .
Keep the button pressed for over 2 seconds to zero the value.
nd st
Leave the "day" function to go back to the 2
manu and then to the 1 .
SERR : Blade group tightening. This mode adjusts the nut (23) locking showing up to 4 small squares on the display.
1 flashing square= too little tightened
2 - 3 fixed squares = exactly tightened
4 flashing squares = too tightened
ANG1 - ALG1 : Cutting blade closing adjustment: This mode allows to perfectly close the blade by means of preset releases
(4 for PONY - 5 for Cobra).
Each release is a blade (17) movement towards the anvil (18).
When pulling up the trigger (15) once after having selected AnGl - ALG1, the writing d=0 will appear.
Adjust the blade closing by quickly pulling the trigger (15) (0-4 releases for PONY, 0-5 releases for COBRA).
Once the desired adjustment has been reached, keep the selector button (22) pressed for 2-3 seconds to go back to the main
menu.
Check the blade for proper tightening. If the adjustment is not right, repeat the operation.
Battery self-stopping
After 20 minutes without being used the battery stops.
To start it again put the ON/OFF switch (11) in OFF position (0), wait few seconds and then put it in ON position (I).
Error messages:
E1 - CABL = No shear is connected.
If the cable is accidentally cut, a protection engages to avoid damaging the flexible circuit board inside the battery (1).
OFF = The shear has been connected after switching the battery on. It can be reset by pulling the trigger two times.
Campagnola Srl – USE AND MAINTENANCE MANUAL – Translation of the original Instructions
Ver.1.0 - Rev.: 01, Data: 21/01/2016 Mod. FOEL.600/601/602 - POWE.0200
Pag.35