KPS -PA60 Manual De Funcionamiento página 26

with an effective voltage above 60V DC or 30V rms AC.
• Do not take voltage measurement if the value between the terminals and
earth ground exceeds 600V.
• Select the highest range if the value scale to be measured in the manual
range is unknown.
• Disconnect the test leads from the circuit under test before turning the rotary
selector to change functions.
• Do not measure the resistance, capacitance, diode or continuity of live cir-
cuits.
• Do not connect the meter to any voltage source while the rotary selector is in
the current, resistance, capacitance, diode or continuity range.
• Do not take capacitance measurements until the capacitor to be measured
has been fully discharged.
• Do not use the meter near explosive gases, steam or dirt.
• Stop using the meter if any abnormalities or faults are observed.
• Do not use the meter unless its rear case and battery cover is securely fas-
tened in its original position.
• Do not store or use the meter in areas exposed to direct sunlight, at high
temperature or with high relative humidity
1.3 Symbols
Caution, risk of danger (Important safety information; refer to the
operation manual.)
Application around and removal from HAZARDOUS LIVE conduc-
tors is permitted.
Double insulation (Protection class II).
Overvoltage (Installation) category III, Pollution Degree 2 per
CAT III IEC61010-1 refers to the level of Impulse Withstand Voltage pro-
tection provided.
Conforms to European Union Directive
Earth (ground) terminal
KPS-PA60 • Digital clamp meter
26