Measuring Dc Voltage - KPS -PA60 Manual De Funcionamiento

test value might be obtained.
2) For optimum results, press the "REL" button to make the meter get into zero
first.
3) For optimum results, center the conductor in the jaw.
4) At the manual range mode, when only „OL‟ or „-OL‟ is shown¡ on the LCD,
it means the measurement has exceeded the range.
A higher range should be selected.
5) Under the manual range mode, when the scale of the value to be measured
is unknown beforehand, set the range to the highest.
6) " " means the maximum input current is 1000A DC.
4.11 Measuring AC Voltage
Beware of Electrocution. Pay special attention to avoid electric shock
when measuring high voltage. Do not input the voltage which more
than 600V rms AC.
• Plug the black test lead into the COM jack and the red test lead into the
INPUT jack.
• Set the rotary selector to V~ position to make the meter get into AC V range.
• Connect the test leads to the voltage source or load terminals for measure-
ment.
• Take the reading on the LCD.
NOTE:
1) " "means the maximum input voltage is 600V rms AC.
2) If the test result is more than 600V rms AC, symbol "OL" will be displayed on
LCD and the build-up buzzer will sound.

4.12 Measuring DC Voltage

Beware of Electrocution. Pay special attention to avoid electric shock
when measuring high voltage. Do not input the voltage which more
than 600V DC.
• Plug the black test lead into the COM jack and the red test lead into the
KPS-PA60 • Digital clamp meter
WARNING
WARNING
40