ASSEMBLY
The Vacuum Cleaner Assembly
Canister
1. Inspect Canister
2. Check to see that Dust Tank is properly installed.
See the "Emptying the Dust Tank" section for
instructions.
3. Check to see that the dust separator and exhaust
filters are properly installed.
See the "Cleaning the Foam Pre Filter" section
for instructions.
Telescopic Wand
1. Grasp and hold the latch to adjust reach.
2. Pull out the wand to the desired length.
latch
8
Hose
1. Insert the hose into the canister until it locks into
place. To remove the hose from the canister,
press the release button and pull the hose out.
Fitting pipe
Flexible Hose
Release button
2. Line up the electrical connectors and insert the
telescopic wand firmly into hose handle.
Hose Handle
Power Nozzle
Line up the electrical connectors and push the Power
Nozzle into the telescopic wand until it clicks into place.