Corghi EM 9550 Plus Manual De Uso página 54

Take great care to position the arm correctly
so as to ensure accurate data reading.
While moving the automatic arm, the distance
measured by the arm is shown on the display:
When the measurement is stored, the value of
the distance acquired by the machine will remain
visible on the left display:
- if only one measurement is taken, the machine
interprets the presence of a rim with balancing
using a clip weight on both sides (Dynamic
Balancing Programme)
- moving the arm to the rest position, the machine
will set up for the manual WIDTH entry.
- in this phase, it is possible to perform an ad-
ditional acquisition of the rim diameter and
distance.
- Measure the width of the rim using the calliper
provided (fig.17).
54
16a
- Modify the width value displayed by pressing
the
value is set.
The WIDTH can be set in millimetres or the
values already set can be converted from inches
to millimetres by pressing the
Keep the
rapidly increase or decrease the previously
set values.
After completing the wheel data update, press
the
16b
balance values recalculated according to the new
dimensions, or to perform a wheel spin.
- if two subsequent measurements are taken
inside the rim on two balancing planes, the
machine interprets the presence of a rim with
balancing using a clip weight on the inner
plane and an adhesive weight on the external
one (ALU 2P).
In this phase, the machine could automatically
change the type of weight on the inner plane from
clip to adhesive (ALU 1P). The operator is able
to change this setting by pressing the
button. In this case, the balancing programme
switches from ALU 1P to ALU 2P and vice versa.
EM 9550 Plus - EM 9550 C Plus - Operator's manual
buttons until the desired
keys pressed to
button to exit and display the un-
17
button.