Lighting Led And Laser Activation/Deactivation; Wheel Roundness Visual Inspection - Corghi EM 9550 Plus Manual De Uso

gramme status;
- The position search is eliminated and the
icon is shown in the LCD display status line;
- Pressing the
allows the user to set one visualisation mode
or the other;
- Press the button to confirm selection
and exit the programme menu.
LIGHTING LED AND LASER
ACTIVATION/DEACTIVATION
To change or deactivate the control of the LED light,
proceed as follows:
- Press the button to access the pro-
gramme menu
- use the
cursor
- select the programme
- press the button to confirm programme
selection;
- Pressing the button consecutively allows
the user to set alternatively the three light control
modes, as follows;
LEd 1. In this configuration, the light turns on
when:
- at the end of a spin cycle if residual unbalances
are present for 30 seconds;
- in CP (centred position) for an additional 30
seconds.
LEd 2. In this configuration, the light turns on in
the conditions indicated for the LEd1 programme
and, in addition, also in the following conditions:
- when the internal sensor is extracted. When
the sensor returns to the rest position, the light
turns off;
- during the entire measurement cycle with all
balancing programmes;
- during the Hidden Weight programme when
selecting the two planes behind the spokes.
LED OFF: deactivated
EM 9550 Plus - EM 9550 C Plus - Operator's manual
button consecutively
buttons to move the
- Press the button to confirm selection
and exit the programme menu.
To deactivate the switching on of the LASER line,
proceed as follows:
- press the button to access the pro-
gramme menu
- use the
cursor
- select the programme
- press the button to confirm programme selection;
- press the or button to confirm pro-
gramme selection;
- Pressing the
makes it possible to alternatively set the two
LASER line control modes (LAS on or LAS oFF)
- Press the button to confirm selection
and exit the programme menu.
WHEEL ROUNDNESS
VISUAL INSPECTION
This function allows the wheel to be run at low
speed and with the guard open, Any geometrical
irregularities of the rim and wheel can therefore be
visually checked. Follow the description detailed
below to start the procedure:
keep the button pressed with the guard
open for as long as necessary for wheel inspection.
When the button is released, the wheel-holder shaft
locking device activates automatically.
buttons to move the
button consecutively
69
UK