The Hedge Cutter; Hedge Cutter Parts; Hedge Cutter Assembly - Trueshopping MT260 Manual Del Usuario

• Do this until you hear a splutter or cough
from the engine. Once this has happened,
push the choke lever down and pull the
starter cord and the engine will start. You
can then pull the throttle trigger to start
the tool working.
**Please note that it can take several
attempts at pulling the starter cord to
start the machine.
•
To turn the machine off push the on/off
switch to "O".

The Hedge cutter

The hedge cutter is ready assembled and just
needs to be attached to the main engine unit.
Refer to the "Pole attachment" guide on how
to do this.
When you are ready to use the hedge cutter
ensure that the unit is switched off and then
remove the plastic guards from the blades
**TAKE CARE WHEN HANDLING THE HEDGE
CUTTER AS THE BLADES ARE SHARP **

Hedge cutter parts

1. Cutting blade: Steel blade for cutting
hedges and bushes.
2. Blade Guard: Protect the cutting rail
when the tool is not in use.
3. Blade gear: Convert the rotation of
the angle gear when the cutting blade
moves back and forth.
4. Locking mechanism: Holds the cutter
in the desired position.
5. Angle Gear: Transmits the rotational
movement of the drive axel to the
blade gear.
6. Adjusting lever: Adjust the cutting rail
to the desired angle.
7. Locking lever : Lock and unlock the
cutting rail
8. Drive shaft tube: Surrounds and
protects the drive shaft between the
coupling sleeve and gear.

Hedge cutter assembly

10