Attaching The Bump Head - Trueshopping MT260 Manual Del Usuario

•
Finger tighten the locknut anti clockwise
and then tighten fully with the socket
tool.
•
Finally, remove the Allen key.
•
The blade in now ready for use.

Attaching the Bump head

This instruction shows you how to attach the
trimmer bump head to your multi tool.
•
Remove the nut and large bell washer
from the head assembly (as shown in the
brush blade instruction)
•
Rotate the large washer until the hole in
the side lines up with the hole on the
head assembly. Then insert the 4mm
Allen key through the two holes to
prevent the assembly from moving.
• Pick up the bump head and place the
threaded connection on the bump head
onto the threaded connection point in the
centre of the head assembly.
•
Screw the bump head onto the central
fixing by rotating it anti clockwise, it is
important that you hold the Allen key
16