Adjusting The Idle Screw; Fuel Pipe / Grommet Exchange - Trueshopping MT260 Manual Del Usuario

•
Keep the area free of people /
pets.
•
Read the manual fully before
operation
•
Not to be used for felling trees,
this is designed to cut small
branches and pieces of wood.

Adjusting the idle screw

To increase and decrease the idle adjustment
(the speed and frequency between engine
revs and power of the machine) please follow
the information below.
•
Start the engine and place the
product on a flat surface.
• Locate the idle adjustment
screw.(Underneath the air filter
assembly)
•
Using a flat headed screwdriver, turn
the screw in either direction or listen
to the noise from the engine as a
guide to the current engine speed.
! Please note, if the screw is wound in/out
too far, the engine will stall.
Fuel pipe / Tank grommet exchange
! Please ensure the unit is completely
drained of fuel before attempting this
procedure.
•
Unscrew the retaining cap and
remove the air filter cover. **The
retaining cap will be a Philips screw
on certain models**
•
Remove the fuel pipes from the
carburettor using long nosed pliers
and a small flat headed screwdriver,
noting the location of each pipe
before removal.
Black pipe = Feed/Supply
Clear Pipe = Return
19