Carburettor Exchange - Trueshopping MT260 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 146
Remove the foam air filter by carefully
pulling it away from the engine body
If cleaning the filter, inspect for and
brush off any debris. Then clean in
warm soapy water and allow to fully
dry before putting it back onto the
machine
If replacing, discard the old foam filter
and fit the replacement in its place.
*To help prevent fine dust particles
from entering the engine add a few
drops of motor oil to the foam filter
and scrunch it up in your hand before
replacing.
Finally, replace the air filter
cover and fasten it back into
position.
Carburettor exchange / inspection
The following procedure will show you
how to remove your carburettor and
either exchange or inspect it for problems
• The carburettor is accessed by
removing the screw or unfastening the
plastic fastener (model dependant) as
circled below.
26

Publicidad

Tabla de contenido
loading

Tabla de contenido