Power Supply - GYS PORTASPOT 230 Manual De Usuario

DESCRIPTION
Thank you for your purchase! In order to make the most out of your device, please read what follows thoroughly:
Portable Spot Welder with microprocessor controlled digital interface.
The main settings that can be managed from the control panel are:
- Thickness of the metal sheets
- Welding time
- Welding with one pulse or with automatic multiple pulses
- Clamping force
This machine is meant to weld standard mild steel metal sheets, up to a thickness of 2+2 mm.

POWER SUPPLY

The absorbed effective current (I1eff) for maximum use is indicated on the machine. Check that the power supply and
its protections (fuse and/or circuit breaker) are compatible with the machine's required current when in use. The ma-
chine must be placed in a way that the power socket plug remains accessible. Do not use any extension with a section
below 4 mm² and longer than 10m.
Connect the power cable to a standard plug (2P + T: SINGLE PHASE 230V connection) with the right capacity and pre-
pare a mains socket protected by fuses or an automatic magnetothermal switch; the ground terminal provided for this
purpose must be connected to the earth conductor (yellow - green) of the power line.
Warnings
Before making any electrical connections, check that the data plate of the spot welder corresponds to the voltage and
power frequency available on the installation site.
The Spot welding station must be connected exclusively to an electrical system with neutral earthed connection.
To ensure protection against indirect contact, use differential switches of type A.
When connected to a public power network, the installer or user must verify the compatibility of the welding station.
If simultaneous use of several PORTASPOT 230 on the same electrical system, it is recommended to divide the phases
in a balanced way.
Example :
PORTASPOT 230 n°1 PORTASPOT 230 n°2 PORTASPOT 230 n°3
Power supply
DESCRIPTION OF THE PORTASPOT 230
1- Clamping force screw for
the adjustment of the clamping force
to the electrodes.
2- Handle position right / left.
3- Mobile welding arm.
4- Fixed welding arm.
5- Power cable.
6- Information Plate.
7- Welding trigger switch.
8- Handle for sheets' tightening.
8
PORTASPOT 230
L1-N L2-N L3-N
8
3
4
EN
PORTASPOT 230 n°4
L1-N
1
7
5
2
...etc
...etc
6