Maintenance - Jacuzzi J-Sha MI Uso Y Mantenimiento

NOTE
• To check whether there are any errors in progress, aim the
remote control at the receiver and hold the
about four seconds. If the message appears as shown in the
figure, it means that there is no alarm situation.
To return to normal display operation, press any key.
NO
ALARM
OK
16:30
key down for
~4 "

Maintenance

I
Tub maintenance is quick and easy. You need only any neu-
tral non-abrasive liquid detergent, which can also be used to
clean the remote control.
Do not use abrasive cloths, powder detergents, ace-
tone or other solvents.
I
The tub can be regularly polished using an ordinary polish..
I
n the event of scratches or considerable damage, it is nec-
I
essary to contact a Jacuzzi
I
HYDROMASSAGE OUTLETS
• Remove the flange cover (1), using a wide-edged screwdriver
as a lever under the edge.
•
Using the wing nuts, or the cone-shaped spanner (2) provided,
remove the ring nut (3) and the nozzle (4).
• Remove any deposits and wash all the components with water
and liquid soap.
•
Repeat the previous phases in reverse order, making sure that
you tighten the ring nut (3) well.
4
NOTE
During cleaning operations, the nozzle (4) can also be disman-
tled, but make sure that you do not lose the spring clip inside it.
112
® Service Centre.
1
3 2