Application Areas - Beurer FC 76 Instrucciones De Uso

4. To switch on the device, move the ON/OFF
switch to the desired intensity level.
5. Place the hand-held device on your face and move it over the skin. Make sure that
you do not move the hand-held device over one part of the face more than once.
Further details on treatment can be found in Section "6.3 Application areas".
Note
The pressure you apply when using the device should be comfortable and
not painful. Some slight reddening should be expected after use.
6. When you have completed the application, switch off the device using the ON/
OFF switch and disconnect the mains adapter from the socket..
7. Change the single-use filter after each use.
To do this, pull the attachment off from the
top. Use tweezers to remove the single-use
filter.

Application areas

Note
Ensure that the part of your face you are treating is taut when you move the
hand-held device over the skin. You can do this by pulling the skin taut to the side
or downwards with your free hand.
Forehead:
Move the hand-held device slowly and evenly outwards
from the centre of the forehead. Make sure that you do not
treat any part of your skin more than once.
19