Troubleshooting - Brill 400 RLB Manual Del Usuario

Ventilador para céspedes con batería / escoba
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 65

10. Troubleshooting

General
GB
Faults usually occur if the unit
has not been handled, cared for
or maintained properly. The fol-
lowing table contains the most
common faults and remedies to
eliminate these faults. If you have
any other problems, please con-
tact your nearest service centre
authorised by the manufacturer,
or your nearest authorised
specialist dealer.
Fault
Appliance is Switched On.
Either the aerator roller or the
brushes are not rotating.
Sweeping machine does not
collect the refuse.
Aerator cylinder not working.
11. Instructions for correct use, safety instructions
Check each time you use
A
the equipment
Inspect the equipment each time
before you use it. Do not use
the equipment if safety devices
(switch handle, safety covers)
and/or if the cutting device is
damaged or worn. Never dis-
able safety devices.
Check the work area before start-
ing work. Remove any foreign
bodies present (e. g. stones,
22
Caution! Repairs that
A
require specialist
knowledge must only be carried
out by an authorised specialist.
Caution! For safety rea-
A
sons, only use original
spare parts supplied by the
manufacturer or parts that have
been authorised by the manu-
facturer.
Possible Cause
Battery is not charged.
Battery clip contacts soiled.
Aerator roller or brushes
blocked by grass or refuse
in the housing.
Incorrect working method.
Brushes worn.
Aerator cylinder incorrectly
assembled.
Aerator springs worn.
Lawn too high.
branches or bones). Check for
foreign bodies whilst working.
Always wear sturdy shoes and
long trousers when working.
Never work barefoot or when
wearing only light sandals.
Only have cutting tools
replaced by Brill Service or your
authorised specialist dealer.
We expressly point out that in
accordance with product liability
laws, we are not liable for any
damage caused by our units if
this damage is due to improper
repair or if parts exchanged
are not our original parts or
parts approved by us, and if the
repairs were not carried out at
service centre authorised by the
manufacturer or by an authori-
sed specialist. The same applies
to spare parts and accessories.
Remedy
Charge battery.
Clean contacts.
Remove grass or refuse.
Change the working method
(see No. 8).
You can obtain replace brushes
from your Brill dealer or from
Brill Service.
Remove the aerator cylinder and
re-assemble it (see No. 9).
You can obtain replacement
aerator cylinders from your Brill
dealer or from Brill Service.
Mow lawn.
Use /
A
Responsibility
Make sure that there are no
other people (especially children)
or animals within or near the
working area.
Powered equipment can cause
serious injuries! You are respon-
sible for safety in the area where
you are working. Never start the
equipment whilst tilted – risk of
injury!

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido