Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
User Manual for
Modular Ice Cube
Machine
Models CME1356 and
CME1656
Table of Contents
Introduction . . . . . . . . . . . . . . . . . page 2
Warranty . . . . . . . . . . . . . . . . . . page 2
Installation . . . . . . . . . . . . . . . . . page 2
Location and Assembly . . . . . . . . . . . page 3
Plumbing . . . . . . . . . . . . . . . . . . page 6
Electrical . . . . . . . . . . . . . . . . . . page 6
Final Check List. . . . . . . . . . . . . . . page 6
Initial Start Up . . . . . . . . . . . . . . . page 7
Maintenance. . . . . . . . . . . . . . . . . page 9
Failure Analysis. . . . . . . . . . . . . . . page 9
INTRODUCTION
This product manual contains the information needed for the
setup, installation, initial start up, sanitation and
maintenance of this ice machine. Keep it for future
reference.
There are 2 models covered in this manual:
CME1356, with 5 evaporators
CME1656, with 6 evaporators
Be certain that the information applies to the model in
question. If no model is listed, the information applies to all
models.
WARRANTY
The warranty conditions are those supplied by the official
distributor for your area. In case of parts, only genuine
service parts may be used.
Installation Limitations
These ice machines are designed to be installed indoors, in a
controlled environment. They can operate satisfactorily
under a wide variety of conditions. Do NOT operate the
machine in temperatures it has not been designed for. Do
NOT operate the machine above or below the voltage limits
for the particular model. Do NOT operate the machine with
too little or too much water pressure.
Operational Limits
Air Temperature
Water Temperature
Water Pressure
Voltage (50 Hz model)
Inlet water flow required is 10 liters per minute.
All models will fit a standard, 1.2 m wide Scotsman Ice
Storage Bin such as the BH900.
Note: Slope front bins must have an internal baffle.
Scotsman's BH900 has the required baffle.
A stacking kit, for like models, is KSCME6-LG
Scotsman reserves the right to make design changes and/or
improvements at any time. Specifications and designs are
subject to change without notice.
Pre-Installation
Check the nameplate for electrical requirements. The
nameplate is located on the back of the ice machine. While
the model and serial number are on the nameplate, a serial
number plate is located at the front of the machine, near the
purge valve.
2
Min
Max
o
o
10
C
40
C
o
o
4
C
40
C
1 bar
5 bar
207
253
Publicidad
Capítulos
Tabla de contenido
