Final Steps - KTM Power Parts 76512945100 Manual Del Usuario

3
6
8
9
13
A
1
4
2
4
7
8
5
10
12
11
14
A
- Mount the air filter (1) on the seat support plate (2) (included) using the
screw of the seat support plate (included).
- Attach the air filter and seat support plate and tighten with the clamp (3)
(included).
- Secure the seat support plate using the original screws (4).
- Detach the hose (5).
- Remove the screw (6) and remove the entire SLS valve (7) + hose (8).
- Close off the hose (5) with the dummy plug (included) and secure it with
a clamp.
- Remove the battery cable (9).
- Mount the battery cable (included) and route it forward toward the bat-
tery.
- Secure the battery cable to the frame using the cable ties (included).
- Connect the battery (see the Owner's Manual).
- Remove the temperature sensor (10) from the original air filter box.
- Mount the temperature sensor plate (11) at position (A) on the frame using
the original screw.
- Mount the temperature sensor (12).
- Attach the connector (13) to the temperature sensor.

FINAL STEPS

Check whether all cables are properly routed and secured with cable ties.
Ensure that the cable is neither kinked nor pinched.
- Mount the frame covers on the left (14) and right.
- Mount the spoiler on the left and right.
- Mount the seat.
- Upload the mapping.