Final Steps - KTM Power Parts AKRAPOVIC Manual Del Usuario

C

Final steps

Make sure that the silencer is not touching any other parts of the motorcycle.
Remove all grease residue with a soft cloth sprayed with multi-purpose lubricant (Motorex Joker 440).
Cleaning prevents stains from baking onto the surface. Do not use aggressive chemical cleaners as they may damage the label.
Test the function of the brakes and suspension. Make sure that all screws are tightened. If the exhaust system is touching the trim or
other parts, readjust the unit or contact your authorized dealer.
When the exhaust system is first put into operation, it is normal for white smoke to be emitted by the silencer. Finally, check for leaks
in the whole exhaust system.
Do not stand behind the exhaust when it is being used for the first time.
Finishing work RC 390
- Remove screws (25).
25
- Remove the exhaust cover.
25
- Adjust the bug spoiler along the marking using suitable workshop tools.
NOTE:
(C) = 4 cm and (D) = middle of the notch
- Install the adjusted bug spoiler in reverse order.
D
The adapter for the lifting equipment (90229955044) cannot be installed
on the right side in combination with the Akrapovic main silencer– Danger
of collision between the adapter and the main silencer.
The rear crash pads (90110945000) cannot be installed on the right side
in combination with the Akrapovic main silencer– Danger of collision between
the crash pads and the main silencer.
The floating axle must be turned by 180° in combination with the Akrapovic
main silencer – Danger of collision between the nut and main silencer.
Rear floating axle nut 90 Nm.