Suzuki 25502-1781 Guia De Inicio Rapido página 6

6/12
9. Connect the coupler B of the
Wiring harness 4 to the TO
sensor and the IMU coupler to
the IMU, and then route the
Wiring harness 4 as shown.
After that, fix the Wiring har-
ness at 4 positions in total with
the Clamps 6 and original
clamp.
Lay the starter motor lead,
battery minus-lead, brake line
(2lines) and Wiring harness 4
in parallel, they must not
cross each other to avoid
touching the bottom of the
fuel tank.
Loose harness (circled part)
may touch the fuel tank.
Please fix the harness with
clamps tightly to avoid touch-
ing.
10.Insert the coupler C of Wiring
harness 4 into the original boot
and fix the harness with original
clamp.
GENUINE SUZUKI ACCESSORIES
NOTICE
NOTICE
Wiring harness 4
Brake line
Clamp
(2lines)
IMU
coupler
Battery
TO sensor
minus-lead
Starter motor
lead
Original clamp
Original boot
Coupler of Wiring harness
Clamp
Original clamp