Suzuki 25502-1781 Guia De Inicio Rapido página 8

8/12
14.Install the Lock-nut 3 and
Gearshift link rod 2 to the
Gearshift sensor 1 and Gear-
shift lever link joint.
NOTE: Position the Gearshift link
15.Turning the Gearshift link rod
2, adjust the gearshift lever
height to 65 – 75 mm (2.6 – 2.9
in).
16.While holding the Gearshift link
rod 2 at width across flats,
tighten the lock-nuts to the
specified torque.
Tightening torque
Lock-nut: 10 N·m (1.0 kgf-m,
7.5 lbf-ft)
17.Connect the coupler of the
Gearshift sensor 1 to the cou-
pler C of the Wiring harness
4.
18.Insert the coupler of the Gear-
shift sensor 1 into the original
boot.
GENUINE SUZUKI ACCESSORIES
2
rod so that the length of
the both threaded portions
become equal.
Gearshift sensor
Lock-nut
Gearshift link rod
Lock-nut
Original boot
Coupler of Gearshift sensor
Foot rest
65-75 mm
(2.6-2.9 in)
Gearshift lever
Gearshift
link rod
Original
lock-nut