Beninca ESA BASIC Manual Del Usuario página 12

MENU
Presetting of the channel status (normally open/ normally closed).
IST: Channel preset as "Gate input status" See section "Gate input status".
In 1
NO: Channel preset for a NO (normally open) input.
NC: Channel preset for a NC (normally closed) input.
Presetting of channel 2 status Same options as channel 1.
In 2
-------
----
Presetting of channel 6 status Same options as channel 1.
In 6
MENU
OUT 1
OUT 2
add
OUT 3
OUT 4
roll
code
bYou
fiX
If this function is selected, the receiver waits for (
ry.
CLR
If the code is valid, it will be erased and
If the code is not valid, or it is not in memory, the message
The receiver memory is totally erased. When the wording
res
confirmed.
(During reset, the
MENU
Measurement of the current consumption in standby (powered control unit with stopped motor).
The operation needs to be confirmed. During measurement, the wording
At conclusion of the operation, the system returns to TAR Menu.
tar
The value is memorised and used by ESA-BASIC as reference of consumption in stand-by, for the
counting of the TOFF time. In order not to have an incorrect reading, the measurement shall be at
motor stopped.
The value (expressed in Amperes) of the output current that ESA-BASIC supplies to the control unit
iout
is displayed.
RESET. WARNING!: Restore ESA-BASIC to default values.
With the first pressure of the <PG> push button, the message
res
pressed again, the message
Note: The transmitter codes are not erased from the receiver.
12
FUNCTION
Outputs 1/2/3/4 can be activated by a radio transmitter.
Select the desired output, the receiver awaits for (
signed to the channel.
Press the transmitter key to be assigned to the output.
If the code is valid, it will be memorised and
If the code is not valid, the message
The reception of variable transmitter codes is enabled/disabled (default ON).
The reception of BYOU transmitter is enabled/disabled (default ON).
The reception of programmable transmitter is enabled/disabled (default ON).
RES
wording flashes. At end of reset,
PROG
FUNCTION
OK
Err
is displayed.
Push
) a transmitter code to be erased from memo-
OK
is displayed on the monitor.
PUSH
OK
FUNCTION
OK
is displayed and then
Push
) a transmitter code to be as-
is displayed on the monitor.
Err
is displayed.
is displayed, the operation must be
is displayed).
MIS
flashes.
PUSH
is displayed. If the push button is
is displayed at end of reset.
ON-OFF
MEMO
(Default)
(NO)