Microscope Assembling - Optika Italy B-1000 Serie Manual De Instrucciones

7.3

Microscope assembling

7.3.1 B-1000POL
1. Insert the Bertrand lens ① on the frame and
lock the locking screw ② with the provided Allen
wrench. (Fig. 1)
2. Insert the optical head on the Bertrand lens and
lock the locking screw with the provided Allen
wrench. (Fig. 2)
• Hold the head with one hand during the
locking in order to avoid that the head falls.
3. Insert both eyepieces into the tubes of the optical
head. (Fig. 3)
• One of the two eyepieces is equipped with
a crosshair for centering the entire optical
system. It is advisable to insert the eyepiece
with crosshair in the right eyepiece sleeve.
4. Insert the condenser under the stage: position
until it is well inserted into its holder (under the
condenser there is a pin that must fully enter the
holder guide). (Fig. 4)
5. Lock the condenser fixing knob ①.
①
Page 10
②
F ig. 1 F ig. 1
F ig. 2 F ig. 2
F F ig. 3 ig. 3
①
F ig. 4 F ig. 4