Festo HMPL-M Serie Instrucciones De Utilizacion página 17

HMPL-...-M..-...
3 Conditions of use
Please note
The intermediate position module modifies the technical specifications of the
linear module (e.g. the permitted extending and retracting times).
S Follow the operating instructions for the HMPL-... .
S Compare the operating instructions for the HMPL-... and the HMPL-...-M..-...
The lower values are in each case valid.
4 Fitting
Fitting mechanical components
S
Fasten the components of the intermedi-
ate position module as follows:
1. Use the screws provided to fasten the
fastening flange for the positioning el-
ement to the drive plate (A) of the linear
module type HMPL-... .
The tightening torque is 3 Nm.
2. Screw in the positioning element up to the
desired intermediate position (rough set-
ting) in the fastening flange and secure
with lock nut.
The tightening torques of the lock nuts
are shown in the table below.
Festo HMPL-...-M..-... 0009NH English
3 Nm
Fig. 4
Fig. 5
(A)
17