Ideal Vol-Con XL Manual De Instrucciones página 4

ND 3401-1 61-085/086 Vol-Con In
load or circuit.
• The tester indicates both the voltage
type and the voltage level. (See Tester
Operation table)
To Measure DC Voltage:
• Ensure that the plug for the test leads is
fully seated into the banana jacks.
• Connect the tester in parallel with the
load or circuit.
• The tester indicates the voltage type,
polarity, and the voltage level. (See
Tester Operation table)
To Test for Continuity: (61-086 only)
• Ensure that the plug for the test leads is
fully seated into the banana jacks.
• De-Energize circuit before performing
continuity test. Note, if voltage is pres-
ent in the circuit, the tester automatical-
ly switches to voltage indication mode.
• Test for continuity by connecting the
tester to the circuit.
• If circuit has 500kΩ or less resistance,
an audible indication is heard and the
Continuity LED lights. (See Tester
Operation table)
• Reversing prods on the circuit under
test verifies continuity versus low volt-
age +DC.
1/9/07 4:29 PM Page 4