TECNOMOTOR ZIPTEC II TM 530 Manual De Instrucciones página 100

TM 530
Produzido por Tecnomotor Eletrônica do Brasil S/A - REPRODUÇÃO PROIBIDA - Eventuais erros ou defeitos favor comunicar tecnomotor@tecnomotor.com.br
8 - Achievements DC voltage measurements
This function should be used for measurements of positive direct current of 0 to
50V. Never attempt to measure signals with voltage exceeding 50V or may
damage the unit.
Turn on the connection to the probe connector accessories Ziptec.
Place the selector switch in the function Vdc.
Connect the black clamp to a ground point as the negative pole of the vehicle
battery.
Touch the probe Ziptec the wire or terminal to be measured and to keep in touch.
The value of the voltage in volts is shown. Also note that the bar graph is shown.
98