TECNOMOTOR ZIPTEC II TM 530 Manual De Instrucciones página 88

Produzido por Tecnomotor Eletrônica do Brasil S/A - REPRODUÇÃO PROIBIDA - Eventuais erros ou defeitos favor comunicar tecnomotor@tecnomotor.com.br
3 - Control buttons and features
Turns on and off the device. Switches between some specific
1 functions. Enters and moves the cursor in the setup menu of the
oscilloscope.
Cilindors selects the number and type of ignition according to the
2 engine RPM of the functions and permanence. Change the
oscilloscope settings.
Connect the screen light (backlight) and auxiliary lighting for a few
3
seconds.
Freezes reading on multimeter functions. Confirms oscilloscope
4 setup. Shoot captures the oscilloscope function. Temporarily
activates the screen light (backlight).
Selector Switch: Toggle between main functions: Oscilloscope (Osc.),
5
voltmeter CC (Vdc), Ohmmeter ( ) and Pulse (Pulse).
6 Audible tone (beep).
Screen shows the measurement values, waveforms oscilloscope and
7
other indications.
8 Probe piercing.
9 Accessory connector, connection to ground and probe.
10 Connector for battery charger.
Reset hole (rear of unit): used to reset via hardware Ziptec if there is a
11 malfunction due to noise or interference. Insert the tip of a paper clip and
pressing the key inside. Then reconnect the Ziptec.
12 Auxiliary lighting.
TM 530
86