TECNOMOTOR ZIPTEC II TM 530 Manual De Instrucciones página 99

TM 530
Produzido por Tecnomotor Eletrônica do Brasil S/A - REPRODUÇÃO PROIBIDA - Eventuais erros ou defeitos favor comunicar tecnomotor@tecnomotor.com.br
7 - Realizations resistance measurements
Turn on the connection to the probe connector accessories Ziptec.
Place the selector switch in the function Ω.
Connect the black clamp to one end of the component that will measure its
resistance.
Touch the probe Ziptec the other terminal of the component and keep in touch.
Scaling is automatic.
The resistance value of the component shown in Ohms. Also note that the bar
graph is shown.
Every component to be tested must be disconnected from the vehicle electrical
system.
97