KTM 78113900100 Guia De Inicio Rapido página 6

3
7
5
2
9
8
6
6
1
4
6
8
10
5
2
4
3
4
5
Scope of supply:
1x brake line (1)
x copper seal rings (2)
1x hose (3)
2x clamps (4)
1x hose nozzle (5)
1x blank plug (6)
4x cable binders (7)
Preparations
- Take off the seat.
- Remove the fuel tank.
- Disassemble the start number plate or the headlight mask with the
- Remove the screws (8) and take off the lid (9).
- Extract the brake fluid from the reservoir with a bleeding syringe (not
included in the scope of supply).
- Remove the banjo bolt (10) and disassemble the clutch line from the mas-
ter cylinder.
- Disassemble the clutch line from the clutch slave cylinder.
NOTE:
Immediately wash off emerging brake fluid with water.
-
- Fix the hose (3) to the hose nozzle (5) using the clamp (4).
- Fill brake fluid into the hose until the fill level in the hose is approximately
8 cm.
NOTE:
The correct brake fluid to use is specified in the Owner's Manual of your vehi-
cle.
- Fix the blank plug (6) to the hose with the clamp (4).