Programming Your Wx-80; Factory Default Programming; Important - Maxon TRUTALK WX-80 SAME Instrucciones De Uso

VII. LISTENING TO A WEATHER..., Continued
1. With the WX-80 powered ON, push the "WEATHER"
button to activates the monitor audio circuitry.
2. Adjust the audio volume to the desired listening
level using the Volume Up / Down bar. Volume
settings range from 1 - the lowest setting, to
8 - the highest setting. The audio volume control
has a mute setting (volume setting 0) that will
allow you to temporarily mute all audio.
3. To turn off the weather broadcast, press the
WEATHER button again.
VIII. PROGRAMMING YOUR WX-80

Factory Default Programming

Your weather monitor is preprogrammed to receive
broadcasts for ALL area broadcasts and ALL weather
alert types. This is called "All Signals Code", (refer to
Table of Contents for page number). The first time
you use your weather monitor, you will find that it is
automatically set to use the NOAA weather broadcast
frequency 162.550 MHz (Channel 1).
Depending on your location, you may need to select a
different channel, determined by your local area NWS
transmitter frequency. Follow these steps to select your
local broadcast frequency.
IMPORTANT: During all programming modes, if there
9