Setting The Alert Type - Maxon TRUTALK WX-80 SAME Instrucciones De Uso

VIII. PROGRAMMING YOUR WX-80
, Continued

Setting the Alert Type

You can set the WX-80 weather monitor to respond to
an NWS alert broadcast in one of two ways. When the
monitor is powered on and activated by an alert signal,
the following will occur (by setting selection):
VOICE - when activated by an alert signal, the weather
monitor sounds an alert beep or siren for about 8
seconds, then automatically broadcasts the weather for
5 minutes. Then it returns to standby operation. The
display shows the alert description (such as TORNADO
WARNING) until the alert's effective time expires. An
alert could be in effect for several hours.
ALERT - when activated by an alert signal, the weather
monitor sounds an alert beep or siren continuously and
displays an alert description until the alert's effective
time expires. To turn off the alert sooner, press the OFF
button. To hear the NWS voice broadcast, press the
WEATHER button.
NOTE: When the weather monitor's alert expires or
you turn it off, you hear the NWS alert termination tone
(three bursts) for a few seconds before you hear the
voice broadcast. The NWS alert termination tone has
a different sound than the weather monitor's alert tone.
12