Setting The Wx-80'S "All Signals" Code - Maxon TRUTALK WX-80 SAME Instrucciones De Uso

XI. USING THE ALERT FUNCTION, Continued

Setting the WX-80's "All Signals" Code

To set the weather monitor to respond only to specific
FIPS codes you select, choose the codes you want to
program (up to 15 total codes), program those codes
into memory, and set the weather monitor to its multiple
location mode.
To operate the weather monitor using the "All Signals"
code and quickly switch to specific area monitoring,
perform the following steps:
1. Set the weather monitor to "single" as explained
in the "Monitoring Single or Multiple Locations"
section.
2. Program the first location cell (LOC 1) with the code
"99" as explained in the "Entering the FIPS
Location Codes" section.
With the All Signals code (99) stored in the first memory
location code and operating the WX-80 in the single
location mode, you will receive all alert signals - -
regardless of location. You can quickly switch between
"All Signals" and "Specific Area" monitoring.
With FIPS Codes / SAME Geographic codes stored in
any of the other memory location codes (LOC 2 - LOC
15) and operating the WX-80 in multiple location
mode, you will receive only the alert signals directed
to the counties you have specified with the FIPS Codes.
29