Storage; Reset Heater; Troubleshooting - Vornado ATH1 Guia Del Propietario

STORAGE

During the off-season or after extended periods of non-use, you may
choose to store your heater. To ensure long life of the product, it is
recommended to store your heater by following these instructions:
Cleaning is recommended before storage.
1. Unplug power cord and
bundle loosely.
2. Cover, or place back in
retail carton if available.
This prevents the heater
from accumulating
dust over time.
3. Store heater in cool
and dry location.
DISPOSAL
Dispose of all packaging
materials in an environmentally
responsible manner.
12 English

RESET HEATER

RESETTING YOUR VORNADO HEATER
Your Vornado Heater has a multilevel safety shut-off system designed
to prevent overheating. Overheating may occur when the inlets or
outlet are blocked. If this happens, the safety shut off system cuts
power to the heater and you must manually reset the heater.
1. Power heater off, then unplug power cord.
2. Remove any obstructions.
3. Wait 5–10 minutes, allowing heater to cool down.
4. Plug in power cord and place heater in desired position.
5. Press power button On. Your Vornado Heater
should now function normally and return to
last stored setting.
Note: If the safety shut-off system repeatedly
shuts off your heater or if it will not reset
after following the above procedure, call
Vornado Consumer Services Department
toll-free at 1-800-234-0604.

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE AND SOLUTION
Unit fails to power on. Unit is not plugged in. Plug power cord into electrical outlet.
Household circuit breaker / ground fault circuit interrupter has tripped or blown fuse. Reset circuit
breaker / ground fault circuit interrupter, or replace fuse. See IMPORTANT INSTRUCTIONS.
Unit has overheated. Automatic Safety Shut Off has initiated. See RESET HEATER.
Tip-over switch on bottom of unit has been tripped and safety shut-off system has cut power to heater.
Place heater on level surface. See SAFETY FEATURES.
Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.
Unit is not producing a
Ensure unit is set to High Heat and thermostat is set to highest temperature setting.
sufficient amount of heat.
Close all doors and windows to trap heat.
Allow unit to fully circulate heat throughout room; may take several minutes.
Unit is powered on but Press the Power button Off and unplug unit. A cylindrical plunger is on bottom of unit. Push in 4-5 times,
there is no heat. ensuring it is not stuck. Set unit down on flat surface. Ensure power cord is not under unit. Plug unit in and
press Power button On. Turn to highest heat setting.
English
13