Publicidad
Idiomas disponibles
Idiomas disponibles
9. Install bolt guard (BB) and then the 7x20 mm
blade retaining bolt with lock washer (CC). Use
spark plug wrench/screwdriver (DD) to tighten
the bolt in a counter-clockwise direction. Re-
move hex wrench.
Y
Z
DD
X7502236401
10/17
Type B (with side-mounted locking tool hole)
1. Turn the unit over so that the gear case output
2. Align the notch in trimmer head holder (EE) with
CC
BB
3. While holding the hex wrench turn trimmer head
AA
4. Remove trimmer head holder.
X
- 10 -
shaft faces UP.
the notch in the gear case flange. Lock the hold-
er and output shaft by inserting hex wrench (FF)
through the locking hole in the gear case and
into the aligned notches.
(GG) clockwise to remove. Remove the hex
wrench.
FF
GG
EE
Publicidad
