Epson Stylus CX1500 Instrucciones De Seguridad Importantes página 20

Ocultar thumbs Ver también para Stylus CX1500:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Avoid locations that are subject to rapid changes in heat or humidity, shocks or vibrations,
or dust.
Leave enough room around the CX1500 for sufficient ventilation.
Do not place the CX1500 near a radiator or heating vent or in direct sunlight.
Place the CX1500 on a flat, stable surface that extends beyond its base in all directions. It
will not operate properly if it is tilted or at an angle.
Turn off and unplug the CX1500 before cleaning. Clean with a damp cloth only. Do not
spill liquid on it.
Always turn the CX1500 off using the P button. Don't turn off the power using a switch
on a power strip or unplug the CX1500 until the light is off.
Do not block or cover openings in the CX1500 case or insert objects through the slots.
Except as specifically explained in your documentation, do not attempt to service the
CX1500 yourself.
Unplug the CX1500 and refer servicing to qualified service personnel under the following
conditions: if the power cord or plug is damaged; if liquid has entered the product; if the
product has been dropped or the case damaged; if the product does not operate normally
or exhibits a distinct change in performance. Adjust only those controls that are covered
by the operating instructions.
When storing or transporting the CX1500, do not tilt it, stand it on its side, or turn it
upside down; otherwise ink may leak from the cartridge.
Before transporting the CX1500, make sure the print head is capped in the far right
position and the ink cartridges are in place.
This product includes a lamp component that contains mercury (Hg). Please consult your
state and local regulations regarding disposal or recycling. Do not put it in the trash.
Ink Cartridge Safety Instructions
Keep ink cartridges out of the reach of children and do not drink the ink.
If ink gets on your hands, wash them thoroughly with soap and water. If ink gets in
your eyes, flush them thoroughly with water.
To avoid damaging the printer, never move the print head by hand.
Don't remove the cartridge label, or ink will leak.
Don't remove the green circuit board from the cartridge. Installing a cartridge without a
circuit board can damage the printer. Avoid touching the green circuit board, as this can
damage the ink cartridge.
If you remove an ink cartridge for later use, protect the ink supply port on the bottom of
the cartridge from dirt and dust. Place it in a small box, or, if you have the original packaging,
store it in there.
20

Publicidad

Tabla de contenido
loading

Tabla de contenido