Caberg MODUS Manual Del Usuario página 6

ENG
1. INSTRUCTION TO REMOVE/ASSEMBLE THE CLEAR VISOR
1.1 Open the visor until the small arrow printed on the mechanism
matches with the notch on the clear visor. Press the release
button A by driving it towards the back side of the helmet.
Release the visor ( as shown in Pic.1).
1.2 To remove the visor entirely, repeat the same operation on the
other side.
1.3 To reassemble the clear visor, repeat the above steps in reverse
order.
2. INSTRUCTION TO REMOVE THE SMOKED VISOR
2.1 With the chin guard closed, remove the upper front vent cover
by pulling slightly outward (Pic.2).
2.2 With the smoked visor lowered, unscrew the screw B
(see pic.3)
2.3 Open the chin guard then release the smoked visor by pulling
slightly outward (Pic.4).
3. ISTRUCTION TO ASSEMBLE THE SMOKED VISOR
3.1 Drive forward the lever to move the smoked visor (located on
the top of the helmet). (Pic.5)
3.2 Take the smoked visor and accommodate its' arms (lateral
sides and the centre one) into their seating (Pic.6)
3.3 Drive the visor inside, until the hole on the visor centre arm
matches with the screw nut B on the lever on top ( Pic.3).
reposition the upper font vent cover.
WARNING! Do not use the smoked visor during night hours or with
scarce visibility condition.
WARNING! Any adjustments to the smoked visor must be done with
the two-wheeler in still position.
5