Product Specifications; Installation And Lubrication; Torque Adjustment - Ingersoll Rand 180PQ1 Especificaciones Del Producto

Product Safety Information
Intended Use:
These tools are designed to remove and install threaded fasteners.
For additional information refer to Air Pulse Tools Product Safety Information Manual
Form 04584983.
Manuals can be downloaded from www.irtools.com.

Product Specifications

Model(s)
180PQ1
280PQ1
280P

Installation and Lubrication

Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet.
Drain condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily.
Install a properly sized Safety Air Fuse upstream of hose and use an anti-whip device
across any hose coupling without internal shut-off, to prevent hose whipping if a hose fails
or coupling disconnects. See drawing 16585747 and table on page 2. Maintenance
frequency is shown in circular arrow and defined as h=hours, d=days, and m=months.
Items identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
After each 20,000 cycles, or as experience indicates, drain and refill the Impulse Unit
Drive Assembly using the Fluid Replacement Kit (Part No. EQ106S-K400). Lubricate the
hex drive and the output shaft before assembly.

Torque Adjustment

To adjust the torque on these Twin Blade Impulse Wrenches, proceed as follows:
1. Remove the Adjustment Hole Plug.
2. Rotate the Drive Shaft until the Torque Adjustment Screw is visible in the opening.
3. Using a 1.5 mm hex wrench, rotate the Adjustment Screw clockwise to increase the
torque output and counterclockwise to decrease the torque output. Do not rotate the
Oil Plug.
4. Replace the Adjustment Hole Plug.
80167554_ed1
Style
Type
Pistol Insert Bit
Pistol Insert Bit
Pistol Square
6.
7.
8.
9.
Drive
Size
1/4"
3/8"
3/8"
Thread size
Coupling
Safety Air Fuse
Oil
EN
Free Speed
rpm
10,500
9,500
9,500
EN-1