3. See Figure 2-4. Attach gun hook by align-
ing holes and pushing tree clips into holes
until flush with gun hook.
Figure 2-4. Attach Gun Hook
4. See Figure 2-5. Attach lance hook by
aligning holes and pushing tree clips into
holes until flush with lance hook.
Figure 2-5. Attach Lance Hook
5. See Figure 2-6. Place recoil rope into
holder.
Figure 2-6. Recoil Rope Hook
6. See Figure 2-7. Insert and snap nozzles
into spaces provided on billboard.
Figure 2-7. Insert Nozzles
Operator's Manual for Power Washer
7. Place spray gun and nozzle extension into
spray gun holder.
Add Engine Oil
1. Place power washer on a level surface.
2. Verify oil fill area is clean.
3. Remove oil fill cap and wipe dipstick clean.
000371
4. Add recommended engine oil.
NOTE: Some units have more than one oil
fill location. It is only necessary to use one
oil fill point.
5. Thread dipstick into oil filler neck. Oil level
is checked with dipstick fully installed.
6. See Figure 2-9. Remove dipstick and ver-
ify oil level.
000372
7. Install oil fill cap/dipstick and hand-tighten.
Fuel
000373
Explosion and Fire. Fuel and vapors are extremely
flammable and explosive. Add fuel in a well
ventilated area. Keep fire and spark away. Failure to
do so will result in death or serious injury.
Fuel requirements are as follows:
• Clean, fresh, unleaded gasoline.
• Minimum rating of 87 octane/87 AKI (91
RON).
• Up to 10% ethanol (gasohol) is acceptable.
• DO NOT use E85.
• DO NOT use a gas oil mix.
• DO NOT modify engine to run on alternate
fuels.Stabilize fuel prior to storage.
000374
1. Verify unit is OFF and cooled for a mini-
mum of two minutes prior to fueling.
Figure 2-8. Remove Dipstick
Figure 2-9. Remove Dipstick
DANGER
000115
000116
(000105)
5