Balluff BTL7-S5 Serie Instrucciones Breves página 6

BTL7-S5 _ _ (B)-M _ _ _ _ -A/B/Y/Z(8)-SA360-KA _ _ -ZA10
Micropulse Transducer - Rod Style
Installation
NOTICE!
Interference in function
Improper installation can compromise the function of the
transducer and result in increased wear.
► The mounting surface of the transducer must make
full contact with the supporting surface.
► The bore must be perfectly sealed (O-ring/flat seal).
Only use the proper nut for the mounting thread. Firmly
tighten the transducer with a maximum torque of 100 Nm.
If installing horizontally with nominal lengths > 500 mm, we
recommend tightening the rod at the end (only possible
with Ø 10.2 mm) or supporting it.
If installed in a hydraulic cylinder, the magnet should not
make contact with the rod. Minimum bore diameter in the
support piston:
Tube diameter
10.2 mm
8 mm
Square flange
M12x1
The square flange is included in the scope of
delivery.
2 english
Bore diameter
At least 13 mm
At least 11 mm
Mounting hole
Hydraulic cylinder
Installation in hydraulic cylinders
1. Lead the M12 contact insert through the mounting hole
and out of the cylinder.
2. Support the contact insert on the 8-mm open-end
wrench. Attach the square flange onto the M12 contact
insert and press it with force until the insert audibly
engages.
Square flange
M12 contact insert
When mounted, the contact insert protrudes from the
bottom of the square flange by approx. 2 mm.
2
3. Fasten the square flange to the hydraulic cylinder using
4 screws. When installed, the connector complies with
protection category IP67.
8-mm open-end wrench
Top view