GE GSM23YBP Manual De Uso Y Cuidado página 53

Filter
Bypass
Plug
SmartWater
Installing the Filter Cartridge
There is an adapter attached to the top of the new
filter cartridge.
The adapter must be removed before installing the
cartridge. To remove the adapter, turn it to the left
about 1/4 turn.
Fill the replacement cartridge with water from the
tap to allow for better flow from the dispenser im-
mediately after installation.
Line up the arrow on the cartridge and the car-
tridge holder. Place the top of the new cartridge up
inside the holder. Do not push it up into the holder.
Slowly turn it to the right until the filter cartridge
stops. DO NOT OVERTIGHTEN. As you turn the
cartridge, it will automatically raise itself into posi-
tion. The cartridge will rotate about 1/2 turn.
Run water from the dispenser for 5 minutes to clear
the system and prevent sputtering.
LCD Models:
Press FILTER REPLACED button to confirm re-
placement.
Non-LCD Models:
Press and hold the RESET FILTER pad (on some
models) on the dispenser for 3 seconds.
NOTE: A newly installed water filter cartridge may
cause water to spurt from the dispenser.
Filter Bypass Plug
You must use the filter bypass plug when a replace-
ment filter cartridge is not available. The dispenser
and the icemaker will not operate without the filter
or filter bypass plug.
Replacement Filters:
To order additional filter cartridges in the
United States, visit our Website, ge.com
MSWF
Suggested Retail $36.95–$41.95 USD
Customers in Canada should consult the yellow
pages for the nearest Mabe Service Center.
51