Adjusting The Ridging Disks - Checchi & Magli PLASTIC - STOP PLUS Serie Manual De Uso Y Mantenimiento

Adjusting the ridging disks

The ridging disks are used to cover the edges of the plastic mulch sheet with soil.
- Adjusting the distance of the disks from the edge of the plastic mulch sheet.
UN41 0247IH
To adjust the disk, proceed as outlined below.
1) Use the handwheel (H) to slacken off spring ten-
sion.
2) Release the spring (B) from the support (F).
3) Loosen the screws (A).
4) Move the arm (C) so that the disk is as far away from
the edge of the mulch sheet (D) as stated in the fig-
ure.
5) Tighten the screws (A).
- Adjusting the disk pressure on the ground
To adjust the disk pressure, proceed as outlined below.
1) Turn the handwheel (H) to increase or decrease the
disk pressure on the ground.
English language
ADJUSTMENT INFORMATION
10÷15 cm
6) Loosen the screw (E).
7) Move the support (F) and place it in position with
the arm (C).
Check that the stroke limit (G) tallies with the arm.
8) Tighten the screw (E).
9) Attach the spring to the support (F).
10) Use the handwheel (H) to tension the spring.
Repeat the same procedure for the other disk.
UN41 0248IH
16
D
Use and maintenance
5
10÷15 cm