Partition For Paper Roll - Citizen CT-S801II Manual De Usuario

3.8 Partition for Paper Roll

Set the partition to the width of the paper roll you are loading.
The partition is set at the factory to the position shown below.
 For 3-inch type: 80-mm wide paper roll
 For 2-inch type: 58-mm wide paper roll, 60-mm wide paper roll
1. Turn off the power.
2. Pull the cover open lever forward and open the pap er cover.
3. Set the partition in a slot that matches the size of the paper roll you are using.
However, to use an 83-mm wid e pap er roll, remove the partitio n.
Or, when you are using a 60-mm wide paper roll with the 2-inch type, remove the
partitio n installed for 58-mm.
4. Refer to "5.3 Manu al Setting of Memory Switches" to change the paper width
settings.
CAUTION
Make sure the partition is not slanted when setting it for 58-mm or 60-mm paper rolls.
Calle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 309
(2-sheet partition installed.)
*1
— 35 —
V10 CONSUMIBLES S.L.
Partition
*1
*2
Notes:
*1: 2-inch type (58/60 mm)
*2: 3-inch type (80/83 mm)