3.1 0
Adjusting the Paper Near-end Sensor
Change the settings of the paper near-end sensor to set the position at which
the near-end of the paper is detected.
1.
Use a pointed object, such as a pen, to gently press the button to change the pap er
near-end sensor.
2.
Press and hold dow n the button whil e moving the pap er near-en d sensor up, down,
right and left. The sensor positions are shown below for the various diameters of the
paper roll used.
When paper thickness is 75 µm or less
Senso r positi on
A, a
B
, b
*
C
When paper thickness is 75 µm or mor e
Senso r positi on
A, a
B
, b
*
C
Note:
*: Position of sensor when shipped from factory. However, factory settings differ depending on the
destination market.
CAUTION
The diameter of the roll of paper that is detected is an estimate. Some variations may
occur depending on the paper.
("A" and "B" are for horizontal installations, and "a" and "b" are for vertical or
wall installations.)
Calle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 309
Exterior diamet er when detected as
near end
Approximately 31
Approximately 23
Paper near-end sensor function is off
Exterior diamet er when detected as
near end
Approximately 41
Approximately 34
Paper near-end sensor function is off
Button to change paper
near-end sensor
V10 CONSUMIBLES S.L.
Exterior/ interior diamet er of core
Exterior/ interior diamet er of core
— 37 —
(Unit: mm)
of paper roll used
18/12
18/12
(Unit: mm)
of paper roll used
32/25.4
32/25.4