Intended Use; Items Supplied - Hilti TE 2 Manual De Instrucciones Original

Ocultar thumbs Ver también para TE 2:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

▶ Always lead the supply cord and extension cord away from the power tool to the rear while
working. This helps to avoid tripping over the cord while working.
▶ Dust from materials, such as paint containing lead, some wood species, concrete / masonry / stone
containing silica, and minerals as well as metal, may be harmful. Contact with or inhalation of the dust
may cause allergic reactions and/or respiratory or other diseases to the operator or bystanders. Certain
kinds of dust are classified as carcinogenic such as oak and beech dust, especially in conjunction with
additives for wood conditioning (chromate, wood preservative). Material containing asbestos may be
handled only by specialists. Use a dust removal system whenever possible. To achieve a high level
of dust collection, use a suitable vacuum cleaner. When indicated, wear a respirator appropriate
for the type of dust generated. Ensure that the workplace is well ventilated. Follow national
requirements for the materials you want to work with.
▶ In the event of a power failure or interruption in the electric supply, switch the power tool off,
unplug the supply cord and release the switch lockbutton (if applicable). This will prevent accidental
restarting when the electric power returns.
▶ If the work involves breaking right through, take the appropriate safety measures at the opposite
side. Parts breaking away could fall out and / or fall down and injure other persons.
▶ Observe the nationally applicable industrial safety regulations.
Electrical safety
▶ Before beginning work, check the working area (e.g. using a metal detector) to ensure that no
concealed electric cables or gas and water pipes are present. External metal parts of the tool may
become live, for example, when an electric power line is damaged accidentally. This presents a serious
risk of electric shock.
▶ Check the power tool's supply cord at regular intervals and have it replaced by a qualified specialist
if found to be damaged. If the power tool's supply cord is damaged it must be replaced with
a specially-prepared and approved supply cord available from Hilti Customer Service. Check
extension cords at regular intervals and replace them if found to be damaged. Do not touch the
supply cord or extension cord if it is damaged while working. Disconnect the supply cord plug
from the power outlet. Damaged supply cords or extension cords present a risk of electric shock.
Personal safety
▶ Wear protective gloves. The rotary hammer may get hot during use. There is a risk of injury (cutting or
burning) if the accessory tool is touched while changing it.
3 Description
3.1 Overview of the product
Three-jaw chuck (TE 2-M)
@
Dust shield
;
Chuck
=
Chuck locking ring (TE 2-M)
%
Depth gauge
&
Function selector switch
(

3.2 Intended use

The product described is an electrically powered rotary hammer. It is designed for drilling in concrete,
masonry, drywall / gypsum board, plastic, wood, metal and for driving and removing screws.
▶ The power tool may be operated only when connected to a power supply providing a voltage and
frequency in compliance with the information given on its type plate.

3.3 Items supplied

Rotary hammer, side handle, depth gauge, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or online at:
www.hilti.group | USA: www.hilti.com
4
English
Printed: 04.10.2017 | Doc-Nr: PUB / 5261120 / 000 / 01
1
)
+
§
/
:
Forward / reverse switch
Grip
Control switch
Lockbutton
Rating plate
Side handle

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Te 2-mTe 2-s

Tabla de contenido