Intended Use - Hilti TE 6-22 Manual Del Usuario

▶ If the battery is too hot to touch, it may be defective. Put the battery in a place where it is clearly visible
and where there is no risk of fire, at an adequate distance from flammable materials. Allow the battery to
cool down. If it is still too hot to touch after an hour, the battery is faulty. Consult Hilti Service or read the
document entitled "Instructions on safety and use for Hilti Li-ion batteries".
Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
→ page 11
Read the instructions on safety and use of Hilti Li-ion batteries that you can access by scanning
the QR code at the end of these operating instructions.
3 Description
3.1 Product overview
3.2

Intended use

The product described is a cordless SDS­Plus rotary hammer drill. It is designed for drilling in steel, wood
and masonry, for hammer-action drilling in concrete and masonry, and for driving and removing screws. The
product can also be used for light chiseling work on masonry and for surface finishing on concrete.
• For this product, use only Hilti Nuron lithium-ion batteries of the B 22 series. For optimum performance,
Hilti recommends the batteries stated in the table at the end of these operating instructions for this
product.
• For these batteries, use only Hilti chargers of the type series stated in the table at the end of these
operating instructions.
3.3 Items supplied
SDS­Plus rotary hammer drill, side handle, depth gauge, grease, operating instructions.
The TE DRS-4⁄6 (01) dust removal module greatly reduces dust emissions and is available as an accessory.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
3.4 Status indicators of the Li­ion battery
Hilti Nuron Li-ion batteries can indicate state of charge, fault messages and the battery's state of health.
3.4.1 Indicators for state of charge and fault messages
WARNING
Risk of injury by a falling battery!
▶ If the release button is pressed with a battery inserted in the product, subsequently check that the battery
is correctly re-engaged and secure.
6 English
1
Dust cap
@
Chuck (blade holder)
;
Connection for the dust collection module
=
Function selector switch
%
Depth gauge
&
Forward/reverse switch with transport lock
(
Control switch
)
Grip
+
Battery
§
Installation opening for accessories
/
Battery release button
:
Battery status indicator
∙
Connection for the TE DRS­4⁄6 (01) dust re-
$
moval module
Side handle
£
Work-area light (LED)
|
2264936
*2264936*