Tabla de contenido
Publicidad
Troubleshooting
Problem
Cause
Air flows continuously
• The texture gun internal valve is activated
through the plastering
with the trigger and may be stuck or dirty
machine.
.
The material is not
• The compressor is too small.
spayed correctly.
• The mix is too thick or is dry.
The material is
scattered when hitting
• The pressure is too high.
the wall or ceiling.
The material is not
being shoot out
• The material was not prepared right.
through the nozzle.
Parque Industrial No.1, Jilotepec, C.P. 54240, Estado de México, México
TRUPER, S.A. de C.V.
TEL. 01(761) 782 91 00, (TIN) R.F.C.: THE-791105-HP2
www.truper.com
03-2019
Solution
• Disassemble the texture gun to clean and
check there are no damaged O-rings. If so,
replace.
• The compressor shall be able to work with
pressure between 40 PSI and 90 PSI.
• Thin the mix with water.
• Verify adjustments. See the textures table. If
using a tank compressor, regulate the air.
• Check the mix preparation procedure.
ENGLISH
9
Publicidad
Tabla de contenido
