ESAB Origo Feed 302 Serie Manual De Instrucciones página 24

5.6) Moving and/ or lifting
To move the feeder around the workplace use a hook, use the lifting eye for lifting, re.: 0401231 according to
the picture below.
6) OPERATION
1) Turn on the power source.
2) Adjust the wire speed, the power source voltage, the burnback time and the shielding gas according to
the wire diameter, thickness and material to be weld.
3) Start the welding and re-adjust the parameters, if needed.
7) MAINTENANCE
7.1) Recomendations
The Wire feeder requires little maintenance in normal environment and opperation conditions. It is sufficient
to blow it dry clean using dry compressed air free from oil once a month.
After cleaning the equipment with blow dry air, check that the electric connections and components are
properly fixed. Check for possible faults in the wire isolations or electric cables, including the welding cable
and any others and if any of them is faulty substitute it.
When working with damaged wires or cable or with worn out isolation, the non-isolated parts, can become
in contact with another part of an earth connected object.The electric arc which results from this contact can
hurt the eyes if not protected and cause a fire. The body contact of a part with another conductor without
isolation can cause a violent electric hazard, burns and even death.
N.B.: Cleaning and preventive maintenance should be intensified when
operating in environment contaminated by dust, soot or any other poluent which
can cause damage or harm to the performance.
ATTENTION:
In case of doubts about the operation or maintenance of this or any other ESAB product brand and
manufacturing, contact the department of Tecnical Service or an authorized ESAB Service.
24
Origo™ Feed 302 P1
Origo™ Feed 302 P2
Origo™ Feed 302 P3