Sauder 412923 Manual Del Usuario página 10

Step 6
Turn eight BLACK 9/16" FLAT HEAD SCREWS (II) into the
å
ENDS (A and B) until the shoulder of the SCREWS rest on
the surface of the ENDS.
Line up the groove in the MOLDINGS over the head of the
å
SCREWS in the ENDS. Slide the END MOLDINGS (N and O)
onto the ENDS (A and B).
Apply pressure with your hands as
you guide the MOLDINGS over the
SCREWS and onto the ENDS.
Shoulder
BLACK 9/16" FLAT HEAD SCREW
(8 used in this step)
Page 10
N
A
II
N
The LOWER END MOLDINGS (O) are wider
than the UPPER END MOLDINGS (N).
B
O
412923
O
www.sauder.com/services