Publicidad
Step 8
Position the BACK (G) over your unit.
å
Make equal margins along the top and bottom edges of the BACK (G).
å
Push on opposite corners of your unit if needed to make it "square".
Fasten the BACK (G) to your unit using the NAILS (LL).
å
NOTE: Perforations have been provided for access through the BACK.
å
Carefully cut out the holes needed.
Turn two CORD CLIPS (X) into the SMALL BACK (F).
å
NOTE: The CORD CLIPS are used to hold your cord against the BACK.
å
X
Page 12
F
412923
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
NAIL
(22 used in this step)
G
LL
www.sauder.com/services
Publicidad
