Operating Instructions - Hammerhead SWITCH HHS1200 Manual De Instrucciones

OPERATING INsTRUCTIONs

1. How To Charge
NOTICE: The integrated battery is
shipped partially charged. before
using it the first time, fully charge
the battery. a fully discharged
battery will normally charge in
about 30 minutes in a surrounding
temperature between 32°f (0°C)
and 131°f (55°C)
a. Charge the tool only with the
correct charger.
b. Lock the variable-speed trigger
switch on the tool by placing the
direction-of-rotation selector in
the center position.
c. align the slots of the integrated
battery with the electrical contacts
of the charger, and then slide the
tool into the charger.
d. Connect the charger to the power
supply. The charger can only be
used with normal household volt-
age of 120 volt aC, 60 Hz.
e. The red and green charging indicator lights will illuminate for approximately one
second and then turn off. The charger will communicate with the tool to evaluate the
condition of the battery.
f. The green light will flash while the battery is charging normally. When charging is
complete, the green indicator light on the charger will illuminate.
g. a flickering red light indicates a defective battery or a bad connection between the
battery and the charger.
h. The battery will fully charge if left on the charger, but it will not overcharge.
NOTICE: for your convenience, the charger can operate with most generators and inverters
rated at 45 watts or higher.
10
1
SWITCH™_12V rIgHT aNgLE IMPaCT DrIVEr – auTO HaMMEr