Hammerhead SWITCH HHS1200 Manual De Instrucciones página 11

OPERATING INsTRUCTIONs
2. Trigger switch
a. To turn the tool ON, depress the
trigger switch.
b. To turn it Off, release the trigger
switch.
NOTICE: The variable-speed trigger
switch delivers higher speed with in-
creased trigger pressure and lower speed
with decreased trigger pressure.
3. Direction-of-Rotation selector
(forward/Center-Lock/Reverse)
The direction of rotation while impact
driving is reversible and is controlled
by a selector located above the trig-
ger switch. With the tool held toward
you as shown in figure 3.
a. Position the direction-of-rotation
selector to the right of the tool for
forward rotation.
b. Position the direction-of-rotation
selector to the left of the tool for
reverse rotation.
c. Setting the switch in the Off (center-lock) position helps reduce the possibility of
accidental starting when not in use.
NOTICE: To prevent gear damage, always allow the tool to come to a complete stop before
changing the direction of rotation.
NOTICE: The tool will not run unless the direction-of-rotation selector is engaged to the left
or right.
SWITCH™_12V rIgHT aNgLE IMPaCT DrIVEr – auTO HaMMEr
2
3
fORWARD
TRIGGER
sWITCH
REVERsE
11