Care And Maintenance; Troubleshooting - Hammerhead SWITCH HHS1200 Manual De Instrucciones

OPERATING INsTRUCTIONs
Recommended Nails to Use
The tool is versatile for use with a variety of nails. Common and finishing nails from 2d to
8d are recommended for use with this tool.
Recommended Nailing Materials for the Impact Driver/Auto-hammer
The tool may be used for nailing into all types of woods, wood-like materials, and plaster
board.
NOTICE: The tool is not suitable for nailing in hard metal or concrete.

CARE AND MAINTENANCE

all maintenance should only be carried out by an authorized service organization.
Cleaning
before cleaning or performing any maintenance, lock the trigger switch on the tool by
placing the direction-of-rotation selector in the Off (center) position. for safe and proper
operation, always keep the tool and its ventilation slots clean.
always use only a soft, dry cloth to clean your impact driver/auto-hammer; never use
detergent or alcohol.

TROUbLEsHOOTING

PRObLEM
The tool does not work
The tool stops rotation
during operation
bit cannot be installed
Motor overheating
16
POssIbLE CAUsE
battery is depleted
battery is depleted
Sleeve is not released
bit does not fit the sleeve
be sure the cooling vents
are free from dust and
obstacles
SWITCH™_12V rIgHT aNgLE IMPaCT DrIVEr – auTO HaMMEr
CORRECTIVE ACTION
Charge the battery
Charge the battery
release the sleeve
use suitable adaptor
Clean and clear vents. Do
not cover with hand during
operation